The Specification
| Item Name | Characteristic | ||
| CategoryTemperature Range | -55 ~ 105℃ | ||
| Rated Volts | 2.5 ~ 25V | ||
| Capacitance tolerance | ±20%(M),at 20℃,120Hz | ||
| Leakage Current | After two minutes applied for rated voltage at 20℃, less than or equal to the specified value. | ||
| Dissipation Factor | Rated voltage (V) | 2.5～25 | at 20℃,120Hz |
| tanδ (Max.) | 0.12 | ||
| Low TemperatureCharacteristics(Max.Impedance Ratio) | Z(-25℃)/Z(+20℃) | ≤1.25 | 100KHz |
| Z(-55℃)/Z(+20℃) | |||
| Endurance | The specifications listed below shall be met when the capacitors are restored to 20°C after the rated voltage is applied for 3000 hours at 105℃. | ||
| Appearance | No significant damage | ||
| Capacitance change | ≦±20% of the initial value | ||
| D.F.(tanδ) | ≦150% of the specified value | ||
| ESR | ≦150% of the specified value | ||
| Leakage current | ≦The specified value | ||
| Damp Heat (Steady State) | The specifications listed below shall be met when the capacitors are restored to 20°C after the rated voltage is applied for 1000 hours at 60℃, 90%～ 95% RH. | ||
| Appearance | No significant damage | ||
| Capacitance change | ≦±20% of the initial value | ||
| D.F.(tanδ) | ≦150% of the specified value | ||
| ESR | ≦150% of the specified value | ||
| Leakage current | ≦The specified value | ||
| Surge Voltage | Surge Voltage=Rated voltage * 1.15(V)The capacitors shall be subjected to 1000 cycles each consisting of charge with the surge voltages specified at 105℃ for 30 seconds through a protective resistor (Rc=1kΩ) and discharge for 5 minutes 30 seconds | ||
| Appearance | No significant damage | ||
| Capacitance change | ≦±20% of the initial value | ||
| D.F.(tanδ) | ≦150% of the specified value | ||
| ESR | ≦150% of the specified value | ||
| Leakage current | ≦The specified value | ||
Dimensions (mm)
| ΦD | 5 | 6.3 | 8 | 10 |
| P | 2 | 2.5 | 3.5 | 5 |
| Φd | 0.5 | 0.5 | 0.6 | 0.6 |
| ɑ | L<16mm：1.0 | |||
| L≧16mm：2.0 | ||||
Standard Ratings
| Rated voltage (V) | Rated capacitance(uF) | Case size ΦD*L(mm) | ESR(mΩ) at 20℃,100 KHz | Rated ripple current (mArms/105℃/100kHz) |
| 2.5 (0E) | 680 | 8*12 | 10 | 5330 |
| 820 | 8*12 | 10 | 5330 | |
| 1500 | 10*12 | 10 | 5600 | |
| 4 (0G) | 560 | 8*12 | 10 | 5330 |
| 1200 | 10*12 | 10 | 5600 | |
| 6.3 (0J) | 820 | 6.3*11 | 16 | 3500 |
| 680 | 8*12 | 12 | 4820 | |
| 1000 | 8*12 | 12 | 4820 | |
| 820 | 10*12 | 10 | 5600 | |
| 1000 | 10*12 | 10 | 5400 | |
| 1500 | 10*12 | 10 | 5600 | |
| 10 (1A) | 330 | 6.3*11 | 16 | 2000 |
| 560 | 8*12 | 12 | 4500 | |
| 1000 | 8*12 | 12 | 4500 | |
| 820 | 10*12 | 12 | 6100 | |
| 1000 | 10*12 | 12 | 6100 | |
| 1500 | 10*12 | 12 | 6100 | |
| 16 (1C) | 220 | 6.3*11 | 25 | 2500 |
| 330 | 8*12 | 13 | 4800 | |
| 470 | 8*12 | 13 | 4800 | |
| 560 | 8*12 | 13 | 4800 | |
| 560 | 10*12 | 13 | 5250 | |
| 1000 | 10*12 | 13 | 5250 | |
| 20 (1D) | 100 | 8*12 | 30 | 2750 |
| 150 | 10*12 | 25 | 2900 | |
| 25 (1E) | 82 | 5*11 | 55 | 1500 |
| 150 | 6.3*11 | 55 | 1500 | |
| 47 | 8*12 | 24 | 2320 | |
| 68 | 8*12 | 24 | 3320 | |
| 270 | 8*12 | 15 | 4900 | |
| 330 | 10*12 | 15 | 4900 | |
| 470 | 10*12 | 15 | 4900 |
Rated Ripple Current Coefficient
| Frequency (Hz) | 120Hz≤f＜1kHz | 1kHz≤f＜10kHz | 10kHz≤f＜100kHz | 100kHz≤f＜500kHz |
| Coefficient | 0.05 | 0.30 | 0.70 | 1.00 |